2891726 - 4420C10 rear suspension stabilizer bar - r+r

Removing ( Refitting ) Position the vehicle on a lift and raise it.1. Move the handbrake cable and left and right brake pipes mounting brackets, undoing the bolts fixing them to the track control arms to facilitate access to the anti-roll bar.2. Undo the bolts (2a) fixing the anti-roll bar to the track control arms and the bolts (2b) for the left and right U-bolts. 3. Undo the bolt fixing the load proportioning valve bracket to the anti-roll bar.4. Remove the rear anti-roll bar. Refitting ( Removing )

The anti-roll bar should show no signs of deterioration or else it must be replaced.

Reposition the anti-roll bar.Tighten the bolts fixing the anti-roll bar to the left and right track control arms to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR ANTI-ROLL BAR	M10 x 1.25	5.6

Tighten the bolts for the U-bolt securing the anti-roll bar to the left and right track control arms to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR ANTI-ROLL BAR	M8	3

Tighten the bolt fixing the load proportioning valve bracket to the anti-roll bar, paying attention to position the bracket on the milled part of the bar, to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	LOAD PROPORTIONING VALVE	M8	2

Reposition and tighten the bolts for the brackets securing the handbrake cable and brake pipes to the track control arms to torque

	Fastening	Component	Ø	Value(daNm)
-	Bolt	HANDBRAKE LINKAGE MOUNTS	M8	2.5

Lower the left and remove the vehicle. Removing ( Refitting ) Position the vehicle on the ramp.Disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1

1. Open the bands (1a) and release the left and right rear wheel handbrake cable (1b).2. Undo the bolts (2a) fixing the flexible rear brake pipes and the bolts (2b) fixing the U-bolts securing the anti-roll bar to the left and right track control arms. 3. Undo the fixing bolts (3a) and remove the anti-roll bar (3b). Refitting ( Removing ) Reposition the anti-roll bar.Tighten the bolts fixing the anti-roll bar to the left and right track control arms to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR ANTI-ROLL BAR	M10 x 1.25	5.6

Tighten the bolts for the U-bolt securing the anti-roll bar to the left and right track control arms to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR ANTI-ROLL BAR	M8	3

Tighten the bolts fixing the brake pipe mounting brackets to the track control arms to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	HANDBRAKE LINKAGE MOUNTS	M8	2.5

Close the bands retaining the handbrake cable to the anti-roll bar.Connect the battery negative terminal.

	Name	Connector
-	Battery	A1

Lower the left and remove the vehicle.