2891364 - 1028H12 set of pistons with connecting rods - r r with cylinder head/s removed

Removing ( Refitting )  - 1084A16  oil dip stick pipe - r r - 1076B50  exhaust pipe attachment to engine - r + r - 1020A20  crank case oil sump - r + r clean seals for sealant application1. Undo bolts (1a) and remove big end bearing cap (1b). then remove big end half-bearing (1c).
Lower the vehicle.1. Remove the connecting rod with the piston.2. Remove the big end bearing shell.
Refitting ( Removing ) 1. Fit the connecting rod - piston assembly and half-bearing (1a) using tool (1b).
Fit the connecting rod - piston assembly in the cylinder block/crankcase so that the number stamped on the small end is facing the inlet side.
Fit the big end half-bearing and tighten the cap bolts to torque.

FasteningComponentØValue(daNm)
-BoltCONNECTING ROD CAP FASTENERSM92.5 + 60°
 - 1020A20  crank case oil sump - r + r clean seals for sealant application - 1076B50  exhaust pipe attachment to engine - r + r - 1084A16  oil dip stick pipe - r r