7030B74 SUN-ROOF WIRING HARNESS - R R OR REPLACE - Fiat - MULTIPLA - eLearn

2892154 - 7030B74 sun-roof wiring harness - r r or replace

) - 3380A44 handbrake/linkage protection - r+r - 7040H34 central pillar trim - r r (left and right) - 7040H42 rear pillar trim - r r (left and right) - 7040B18 l/h or r/h side trim (one) of luggage compartment/load platform - arrange (left and right) - 7040H33 glasses holder (1) lh or rh, on roof trim - r r (left and right) - 7065C34 l/h or r/h sun blind (one) - r+r (left and right) - 5580E22 Anti-theft device VOLUMETRIC SENSORS - R.R. after checking electrical circuit - 7040E50 front modular courtesy light unit - r+r - 7065C30 interior l/h or r/h grab handle (one) - r+r (all) - 7040E17 lh or rh rear courtesy light - r r (left and right) - 7030B32 sliding roof decorative seal(1) front or rear - r r (front and rear) - 7030B64 sun-roof control switch - r+r - 7040H80 parcel rack1. Working on both sides of the vehicle, release the perimeter seal for the door housing in the area of the front pillar trim.2. On both sides of the vehicle, release the pillar trim from the inner retainers using the special tool, then lower it.

	Name	Country
1	Scraper blade	1.878.077.000

1. Undo the bolts on the seat belt cover.2. Remove the cover.3. Remove the retainers using the appropriate tool.

	Name	Country
3	Scraper blade	1.878.077.000

Tilt the front and rear seat backrests backwards.4. Remove the seals of the 4 door frames near the ceiling trim.5. Carefully lower the ceiling trim.

1. Disconnect the electrical connections (1a, 1b, 1c, 1d).

	Name	Connector
1a	Sunroof connection	D45

	Name	Connector
1b	Front sun roof motor	N36

	Name	Connector
1c	Rear sun roof control unit	M83

	Name	Connector
1d	Rear sun roof motor	N37

2. If necessary, disconnect the electrical connection (2a) and keep the bridge (2b).

	Name	Connector
2a	Sunroof connection	D45A

3. Disconnect the retainers and keep the sun roof wiring.

Refitting ( Removing

) Check that the wiring for the sun roof is undamaged and that the individual conductors are firmly attached to the connections.Check that the connections are fitted with the anti-slip devices (secondary lock).If necessary, check the continuity.Position the sun roof wiring.Connect the electrical connections and the retainers for the sun roof wiring.Position the ceiling trim.Fit the seals of the 4 door frames near the ceiling trim.Fit the cover on the central rear seat belt.Tighten the cover bolts.Engage the pillar trim on the retainers.Fit the sealing strip around the door compartment.Lift up the front and rear seat backrests. - 7040H80 parcel rack- 7030B64 sun-roof control switch - r+r - 7030B32 sliding roof decorative seal(1) front or rear - r r (front and rear) - 7040E17 lh or rh rear courtesy light - r r (left and right) - 7065C30 interior l/h or r/h grab handle (one) - r+r (all) - 7040E50 front modular courtesy light unit - r+r - 5580E22 Anti-theft device VOLUMETRIC SENSORS - R.R. after checking electrical circuit - 7065C34 l/h or r/h sun blind (one) - r+r (left and right) - 7040H33 glasses holder (1) lh or rh, on roof trim - r r (left and right) - 7040B18 l/h or r/h side trim (one) of luggage compartment/load platform - arrange (left and right) - 7040H42 rear pillar trim - r r (left and right) - 7040H34 central pillar trim - r r (left and right) - 3380A44 handbrake/linkage protection - r+rCheck that all the parts are fitted correctly and check the operation of removed electrical components.