1040A70 SUBMERGED PUMP ASSEMBLY COMPLETE WITH LEVEL GUAGE CONTROL - R + R - Fiat - MULTIPLA - eLearn

2891247 - 1040A70 submerged pump assembly complete with level guage control - r + r

) With the ignition key in the OFF position, disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1

- 7050A90 rear seat (one) - r re - repair with seat removed - 7040L14 panel brackets (1) covering seat attachments to passenger compartment floor - r rRemove the rear seats: in the centre and on the right side.1. Undo the fixing bolts and remove the left guide (1a) for the right side seat and the right guide (1b) for the centre seat.

1. Lift the pre-cut section of the floor covering to gain access to the fuel pump flap.2. Unscrew retaining bolts (2a) and remove protective cover (2b).3. Disconnect the electrical connection from the electric fuel pump and level gauge.

	Name	Connector
3	Fuel pump and sender unit	N40

4. Disconnect the fuel supply pipe from the quick-release fitting.5. Use tool (5a) to unscrew lock collar (5b), then remove the fuel pump together with the level gauge.

	Name	Country
5a	Key	1.870.736.000

Refitting ( Removing

) 1. Position the fuel pump in the special housing in the tank, taking crea to nsure that the seal (1a) is correctly positioned.

The position of the fuel pump is fixed and is determined by a notch (1b) in the tank housing which should correspond with the projection on the pump drip tray.

Fit the lock-nut and use the tool to tighten to torque.

	Name	Country
-	Key	1.870.736.000

Connect the fuel delivery pipe to the quick-release fitting.Connect the fuel pump and level gauge electrical connection.Tighten the fuel pump protective cover retaining bolts.Refit the floor covering.Refit the seat guides, tightening the fixing bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR SEAT MOUNTING SUPPORT.	M10 x 1.25	3.4

- 7040L14 panel brackets (1) covering seat attachments to passenger compartment floor - r r - 7050A90 rear seat (one) - r re - repair with seat removedWith the ignition key in off position, connect the battery negative terminal.

	Name	Connector
-	Battery	A1