186003412 - 1058AA PRESSURE SENSOR CHECK (BIPOWER)
Carry out the electrical test by connecting a braid (A) between sensor (B) and its connector (C) to supply the sensor and measure the output signal using a voltmeter.- Place the bridge between the sensor and the connector.
- With the ignition switched on, check that the sensor supply is about 5 Volt.
- Check that the output voltage is between 0.5 V (with the tank full) and 4.5 V with the cylinders completely full at a pressure of 200 bar.
 | From May 2004, a new sensor will be introduced that will measure up to 250 bars. |
 | The two sensors will not be interchangeable. |
