2891654 - 3340B76 rigid pipe(one), lh or rh, to rear brake cylinder - r r

Removing ( Refitting ) Place the car on a ramp.1. Use wrench (1a) to disconnect rear brake pipe fitting (1b) from the cylinder.2. Unscrew fitting (2a) and remove rigid pipe (2b) to the rear cylinder.

NameCountry
1aBox wrench for brake fittings1.856.132.000
Refitting ( Removing ) Fit the rigid pipe, tightening the front fitting.Use the appropriate tool to tighten the fitting for the rear brake pipe from the cylinder - 3330A18  front or rear hydraulic brake system - bleed . Removing ( Refitting ) Position the vehicle on the ramp.Disconnect the battery negative terminal.

NameConnector
-Battery  A1 
 - 4450B11  WHEEL (one) rear - R.R.1. Using the special tool, undo the connector on the rigid rear brake pipe (1a) from the flexible connector (1b).2. Remove the pipe retaining clip.

NameCountry
-Box wrench for brake fittings1.856.132.000
1. Using the special tool, disconnect the connector for the rigid pipe (1a) and remove the retaining clip (1b). 2. Disconnect the rigid pipe and remove it from the vehicle.
Refitting ( Removing ) Position the rigid pipe and fasten it using the clip.Using the special tool, connect the connector for the rigid pipe to the rear brake caliper flexible pipe and tighten it to the recommended torque.

NameCountry
-Box wrench for brake fittings1.856.132.000

FasteningComponentØValue(daNm)
-ConnectorRIGID PIPE REAR CYLINDERS (ABS)M10 x 11.6
Using the special tool, connect the connector for the rigid rear brake pipe to the section of the flexible pipe and tighten it to the recommended torque.Fit the pipe retaining clip.

NameCountry
-Box wrench for brake fittings1.856.132.000

FasteningComponentØValue(daNm)
-ConnectorRIGID PIPE REAR CYLINDERS (ABS)M10 x 11.6
- 0010T64 brake and or clutch fluid check level and top up as necessary - 0010T65 hydraulic brake system bleed air  - 4450B11  WHEEL (one) rear - R.R.Connect the battery negative terminal.

NameConnector
-Battery  A1 
Remove the car from the ramps.