2891710 - 4410C10 front suspension stabilizer bar - r+r - check wheel geometry separately

Removing ( Refitting ) Position the vehicle on a lift and raise it. - 4450B12  front or rear wheels (two) - r+r . 1. Undo the nuts fixing the right and left anti-roll bar anchorage rods.2. Undo the bolts (2a) and the left and right U-bolts (2b) fixing the anti-roll bar to the crossmember.3. Remove the anti-roll bar. Refitting ( Removing )

The flexible mountings should not show signs of deterioration, like the anti-roll bar, or else the mountings and the actual anti-roll bar will have to be replaced.

Fit the anti-roll bar.Tighten the bolts for the left and right U-bolts fixing the anti-roll bar to the crossmember to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	HANDBRAKE LEVER	M8	2.8

Tighten the nuts fixing the left and right anti-roll bar anchorage rods to torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	FRONT ANTI-ROLL BAR. ANCHORAGE ROD.	M10 x 1.25	7

 - 4450B12  front or rear wheels (two) - r+r . Lower the lift and remove the vehicle.