2892313 - 7210B45 R.R. REAR WING FRAME

Removing ( Refitting )  - 7210E52  R.R. REAR WING - 7210B35  R.R. REAR OUTER WHEEL ARCHCheck if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary. 1. Use a chamfering machine to remove the weld spots shown in the figure.2. Drill out the weld spots shown in the figure.3. Use a chisel and hammer to remove the wing frame from the car. 1. Use a chamfering machine to remove the weld spots shown in the figure.2. Drill out the weld spots shown in the figure.3. Use a chisel and hammer to remove the wing frame from the car. Use a grinding wheel to remove the spot weld residues.1. Make a hole as shown in the figure.2. Apply the electroweldable paint finish. Refitting ( Removing ) Remove the corrosion-proofing from around the inner and outer edges of the part.1. Make holes in the parts as shown in the figure.2. Apply the electroweldable paint finish. 1. Position the lower reinforcement correctly on the car and secure with Parker screws.2. Use a spot welder to weld the areas shown in the figure.3. Use a MIG welder and fill weld the areas shown in the figure. 1. Position the upper reinforcement correctly on the car and lock with self-locking grippers.2. Use a spot welder and weld the areas shown in the figure.3. Use a MIG welder to weld the areas shown in the figure. Correct any deformations in the panel using a profiled stake and mallet.1. Use a grinding wheel to clean and remove the welding residues. 1. Apply rust-proofing to the areas shown in the figure.2. Seal the areas indicated in the figure.3. Apply foam protection to the areas shown in the figure.4. Apply wax oil protection through the hole indicated. Refit fouling parts. - 7210B35  R.R. REAR OUTER WHEEL ARCH - 7210E52  R.R. REAR WING