3025322 - 4410B40 lower wishbone (with balljoint) of left or right front suspension (one) - r+r -check wheel geometry separately

Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1B

Proceed with the removal  - 4450B10  Front WHEEL (one) - R.R. . Proceed with the removal  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. . Refitting ( Removing ) 1. Refit the front suspension lower wishbone (1a) in its seating and secure by tightening bolts (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	FRONT SUSPENSION LOWER LEVER	M10	(Front suspension crossmember side) 7.1 ÷ 7.9

2. Tighten the bolts securing the front anti-roll bar to the front suspension crossmember to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	FRONT ANTI-ROLL BAR	M8	(Front suspension crossmember side) 3.6 ÷ 4.4

1. Refit the lower fork connecting the front suspension damper to the lower wishbone (1a) complete with bracket (1b) and secure by tightening bolt (1c) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	FRONT DAMPER FORK ON WISHBONE	M12	(Shock absorber side) 7.2 ÷ 8.8

2. Connect the front anti-roll bar joint (2a) to the fork and secure together with bracket (2b) by tightening the nut (2c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2c	Nut	FRONT ANTI-ROLL BAR JOINTS	M10	(Front shock absorber fork side) 4.1 ÷ 5.0

Proceed with the refitting  - 4450C10  front pillar (one), l/h or r/h complete with wheel hub - r+r with wheel removed - check wheel geometry separately .