3024755 - 1008B10 power unit front mount (timing side) flexible block - replace

Removing ( Refitting ) Position the vehicle on the ramp.Proceed with the removal  - 4450B10  Front WHEEL (one) - R.R. (Right side). Proceed with the removal  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Right side). Position a hydraulic jack under the engine.1. Undo the nut securing timing side rigid engine support to the flexible mounting to the recommended torque.Lower the hydraulic jack as necessary.2. Undo the bolts (2a) and remove the flexible mounting for the power unit front support (2b).
Refitting ( Removing ) 1. Place the flexible mounting for the power unit front support (1a) back in its housing and secure it by tightening the bolts (1b) to the recommended torque.

FasteningComponentØValue(daNm)
1bBoltFRONT RUBBER MOUNTSM8(Bodyshell side) 3.2 ÷ 3.9
Using the hydraulic jack, position the timing side rigid engine support in contact with the flexible mounting.2. Tighten the bolt securing timing side rigid engine support to the flexible mounting to the recommended torque.

FasteningComponentØValue(daNm)
2BoltENGINE MOUNT TIMING SIDEM12(Flexible mounting side) 7.9 ÷ 9.7
Remove the hydraulic jack from under the engine.Proceed with the refitting  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Right side).Proceed with the refitting  - 4450B10  Front WHEEL (one) - R.R. (Right side).Remove the car from the ramp.