3024896 - 1084B26 emgine oil intake duct - r r

Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

NameConnector
-Battery  A1B 
Proceed with the removal  - 4450B10  Front WHEEL (one) - R.R. (Right side). Proceed with the removal  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Right side). Proceed with the removal  - 1072C44  exhaust manifold heat shield on bulkhead - r+r . Proceed with the removal  - 1008A44  rear rigid mount - r r . Proceed with the removal  - 1092G10  single engine belt r r . Proceed with the removal  - 1092A10  Crankshaft services PULLEY - R.R. . Proceed with the removal  - 1020A20  crank case oil sump - r + r clean seals for sealant application . 1. Undo the bolts (1a) and remove the engine oil inlet (1b) complete with gasket.
Refitting ( Removing ) Place the engine oil inlet, complete with gasket, back in its housing and secure it tightening the bolts to the recommended torque.

FasteningComponentØValue(daNm)
-BoltOIL SECTION PUMPM71.4 ÷ 1.7
Proceed with the refitting  - 1020A20  crank case oil sump - r + r clean seals for sealant application .Proceed with the refitting  - 1092A10  Crankshaft services PULLEY - R.R. .Proceed with the refitting  - 1092G10  single engine belt r r .Proceed with the refitting  - 1008A44  rear rigid mount - r r . Proceed with the refitting  - 1072C44  exhaust manifold heat shield on bulkhead - r+r .Proceed with the refitting  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Right side).Proceed with the refitting  - 4450B10  Front WHEEL (one) - R.R. (Right side).Connect the battery terminal (-).Refill the engine oil lubrication system  - 1084A10  ENGINE OIL - Check level and top up, if necessary .Remove the car from the ramp.