5530A10 ALTERNATOR - R+R - Alfa - 147 - eLearn

3025525 - 5530A10 alternator - r+r

) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

Proceed with the removal - 4450B10 Front WHEEL (one) - R.R. (Right side).Proceed with the removal - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Right side).Proceed with removal - 1092G10 single engine belt r r . Proceed with removal - 1072C44 exhaust manifold heat shield on bulkhead - r+r . Proceed with removal - 4410A80 damper lower fork - r r . Proceed with removal - 2710A31 intermediate drive shaft - r r . 1. Disconnect the electrical connection from the engine oil pressure warning light switch.

	Name	Connector
1	Engine oil pressure sensor	K30

1. Disconnect the electrical connections from the alternator.

	Name	Connector
1	Alternator	A10

2. Undo the upper alternator fixing bolt.

1. Undo the bolts (1a) and remove the alternator rear bracket (1b).

1. Undo the bolt (1a) and remove the power assisted steering pump protection (1b).

Proceed with removal - 1008A44 rear rigid mount - r r . 1. Undo the lower bolt (1a) and remove the alternator (1b).

Refitting ( Removing

) Refit the alternator in its seating and secure it temporarily with the bottom bolt.Refit the alternator rear bracket in its seating and fix it using the bolts.Tighten the two bolts fixing the alternator to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ALTERNATOR ASSEMBLY	M10	5.0

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ALTERNATOR ASSEMBLY	M10	5.0

Connect the electrical connections to the alternator.Place the power assisted steering pump pulley protection back in its housing and secure it using the bolt.Proceed with refitting - 1008A44 rear rigid mount - r r .Place the modular intake manifold mounting bracket back in its housing and secure it using the bolts.Secure the electrical wiring to the bands on the modular intake manifold mounting bracket.Connect the electrical connection to the engine oil pressure warning light switch.Proceed with refitting - 2710A31 intermediate drive shaft - r r .Proceed with refitting - 4410A80 damper lower fork - r r . Proceed with refitting - 1072C44 exhaust manifold heat shield on bulkhead - r+r .Proceed with refitting - 1092G10 single engine belt r r .Proceed with the refitting - 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R. (Right side).Proceed with the refitting - 4450B10 Front WHEEL (one) - R.R. (Right side).Connect the battery terminal (-).Remove the car from the ramps.