3024713 - 0010M20 120,000km service coupon, emission control versions

Position the vehicle on the ramp.Check that the tyre treads are not unevenly worn.

Some types of tyres are fitted with wear indicators; they have to be replaced as soon as these indicators become visible.

Do not cross-interchange the tyres.

Check that the tyre pressures are correct, including the spare tyre.

The tyre pressures should be checked on cold tyres.

Check that all the lights are working: headlamps, direction indicators, hazard warning lights, boot light, courtesy light, glove compartment light and instrument panel warning lights. Check that the windscreen wash-wipe system is working correctly and if necessary adjust the jets.Check that the windscreen and rear window wiper blades are correctly positioned and not worn.Check operation of front disc brake pad wear indicatorCheck the condition and wear of the rear brake pads.

Visually check:

• bodywork exterior
• underbody protection
• Flexible and rigid sections of the pipes (exhaust - fuel system - brakes)
• rubber components (dust excluders, hoses, bushes etc.)

Visually check the condition of the accessory drive belt.Check the adjustment of the handbrake lever travel  Refer to op.. 3380A04  handbrake - check travel .Replace the air filter cartridge  Refer to op.. 1048A14  air cleaner filtering element - replace. .Check and if necessary top up the coolant level  Refer to op.. 0010T20  coolant change .Check and if necessary top up the brake fluid level  Refer to op.. 3330A10  BRAKE FLUID - Check level and top up, if necessary. .Check and if necessary top up the windscreen washer fluid level.Check and if necessary top up the battery fluid level. Replace the timing belt  Refer to op.. 1032B10  toothed timing belt - r + r for timing adjustment or replacement .Replace the accessory drive belt  Refer to op.. 1092G10  single engine belt r r . Connect the Examiner or other diagnostic instruments to the diagnostic socket (select the relevant control unit).Check the plausibility of all the parameters and if necessary carry out the available active diagnoses.Replace the engine oil and filter  Refer to op.. 0010T12  engine oil and filter replace .Replace the brake fluid  Refer to op.. 0010T62  BRAKE and/or CLUTCH FLUID - Replace. fluid - Includes. washing pipes and bleeding air .Change the active charcoal combination particle filter  Refer to op.. 5010B09  purifying filter (antipollen) filter element - replaceWhen the service is complete, connect the Examiner tester to the tester input on the car and establish a connection with the VDO MANNESMAN INSTRUMENT PANEL.

Before carrying out INSPECTION SERVICE VALUE active diagnosis, check the instrument panel UNITS menu to ensure km or miles are selected according to the unit of measure used in your country

When under Active Diagnosis, run the INSPECTION SERVICE VALUE procedure to store/update the km interval at which the service is carried out.When in the SERVICE menu on the instrument panel, for countries that use km measurement units, ensure that the kilometres displayed correspond to 20,000. A value of 12,427 should be displayed for countries that use miles as a measurement unit.