3026002 - 1084B18 engine oil pump, removed - check at bench

Removing ( Refitting ) 1. Undo the cap (1a) and remove the oil pressure relief valve (1b).2. Undo the bolts (2a) and remove the oil pump cover (2b).3. Remove the drive gear.4. Remove the driven gear.Remove the crankshaft front oil seal. Refitting ( Removing ) Check that the radial clearance between pump casing and driven gear is within the recommended limits; If not, replace the oil pump assembly

	Measurement		Value
-	Radial clearance between driven gear and engine oil ump casing (mm)		0.080 ÷ 0.186

Check that the clearance between the oil pump cover support plane and the upper side of the gears is within the recommended limits; If not, replace the oil pump assembly

	Measurement		Value
-	End float between upper side of gears and engine oil pump cover support surface (mm)		0.025 ÷ 0.070

Check that the height of the spring for the engine oil pressure relief valve is within the recommended limits; if this is not the case, replace the spring.

	Measurement		Value
-	Engine oil pressure limiting valve spring height (mm)		36.0
	Check load (daN)	6.4 ÷ 7.2

1. Fit a new crankshaft front oil seal (1a) using the tool (1b).

	Name	Country
1b	Fitting tool	1.821.247.000

Fit the driven gear.Fit the drive gear.Fit the oil pump cover and tighten the bolts.

Manually rotate the gears so that they do not stick.

Fit the oil pressure relief valve and tighten the cap.