3025034 - 1060F30 fuel delivery manifold - r r

Removing ( Refitting ) Proceed with removal  - 1016A10  sound-proofing cover - r + r . Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

1. Push clips (1a) by hand and disconnect the pipe from the injectors to the fuel recovery manifold (1b), injectors side and move it aside. 2. Undo the connectors (2a), (2b) and remove the pipe from the fuel manifold to the injectors (2c).

Use new pipes from from fuel manifold to injectors upon reassembly.

1. Undo the connectors (1a), (1b) and remove the pipe from the pressure pump to the fuel manifold (1c).

When refitting, fit a new pipe from the pressure pump to the fuel manifold.

1. Disconnect the electrical connection from the fuel pressure sensor.

	Name	Connector
1	Fuel pressure sensor	K83

2. Undo the bolts (2a) and remove the single fuel manifold pipe (2b) complete with fuel pressure sensor (2c). Refitting ( Removing ) 1. Place the single fuel manifold pipe (1a), complete with fuel pressure sensor (1b), back in its housing and secure it tightening the bolts (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	INJECTOR FUEL MANIFOLD (DIESEL)	M8	(Camshaft housing side 23 28

2. Connect the electrical connection to the fuel pressure sensor. 1. Place the pipe from the pressure pump to the single fuel manifold back in its housing and fix it using the connectors without tightening them. 2. Tighten the connector for the pipe from the pressure pump to the single fuel manifold, pump side, to the recommended torque using a suitable spanner.

	Fastening	Component	Ø	Value(daNm)
2	Connector	PRESSURE PUMP LINE TO FUEL MANIFOLD	M14	(Pressure pump side 22 24

3. Tighten the connector for the pipe from the pressure pump to the single fuel manifold, fuel manifold side, to the recommended torque using a suitable spanner.

	Fastening	Component	Ø	Value(daNm)
3	Connector	PRESSURE PUMP LINE TO FUEL MANIFOLD	M14	(Fuel manifold side 22 24

1. Fit the new pipes from the fuel manifold to the injectors and secure them using the connectors without tightening them. 2. Tighten the connectors for the pipes from the fuel manifold to the injectors, injector side, to the recommended torque using a suitable spanner.

	Fastening	Component	Ø	Value(daNm)
2	Connector	FUEL MANIFOLD LINE TO INJECTORS	M12	(Injector side) 2.2 ÷ 2.4

3. Tighten the connectors for the pipes between the fuel manifold and the injectors, fuel manifold side, to the recommended torque using a suitable spanner.

	Fastening	Component	Ø	Value(daNm)
3	Connector	FUEL MANIFOLD LINE TO INJECTORS	M12	Fuel manifold side 22 24

Clean the threaded seats for the above-mentioned pipe on the manifold and the injectors using heptane.

4. Connect the pipe from the injectors to the fuel recovery manifold (4a) to the injectors pushing it until the clips (4b) can be heard clicking into place. Connect the negative (-) battery terminalProceed with refitting  - 1016A10  sound-proofing cover - r + r .