3024832 - 1056B17 throttle body intergral with dvl - r r

Removing ( Refitting ) Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

NameConnector
-Battery  A1B 
Proceed with the removal  - 1048A34  sleeve(s) from flow meter to air supply capacity case - r + r . Proceed with the removal  - 1056B87  ignition/injection system control unit mount - r r . 1. Undo the remaining bolt (1a) and remove the throttle body integrated with D.V.L. (1b).
Refitting ( Removing )
If the throttle body integrated with D.V.L. or the injection control unit is replaced, re-initialise the injection-ignition control unit  - 1056B81  run electronic ignition/injection control unit (single) self-learning procedure
Refit the throttle body with integral DVL in its housing and secure provisionally with the bolt.
Tighten the above bolt to the specified torque at the same time as the remaining bolts that secure the ignition/injection control unit mount are tightened.
Proceed with the refitting  - 1056B87  ignition/injection system control unit mount - r r .Proceed with the refitting  - 1048A34  sleeve(s) from flow meter to air supply capacity case - r + r .Connect the battery terminal (-).