3024841 - 1056B82 injection/ignition system e.c.u. (one) - r + r

Removing ( Refitting ) Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

NameConnector
-Battery  A1B 
1. Disconnect electrical connections (1a) and (1b) from the injection-ignition control unit.

NameConnector
1aEngine management ECU  M10A 

NameConnector
1bEngine management ECU  M10B 
2. Release the electrical wiring from the fastening on the ignition/injection system control unit mount.
1. Undo nuts (1a) and remove the single injection/ignition control unit (1b).
Refitting ( Removing )
If the injection/ignition control unit is replaced, initialise the new control unit.  - 1056B81  run electronic ignition/injection control unit (single) self-learning procedure
Place the single injection/ignition system control unit back in its housing and secure it by tightenng the bolts to the specified torque.

FasteningComponentØValue(daNm)
-NutINJECTION/IGNITION SYSTEM E.C.U.M6(Support side) 0.8÷1.1
Connect the electrical connections to the injection-ignition control unit and secure the electrical wiring to the ignition/injection system control unit mount.Connect the battery terminal (-).