3024842 - 1056B87 ignition/injection system control unit mount - r r

Removing ( Refitting ) Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

NameConnector
-Battery  A1B 
1. Disconnect electrical connections (1a) and (1b) from the injection-ignition control unit.

NameConnector
1aEngine management ECU  M10A 

NameConnector
1bEngine management ECU  M10B 
2. Release the electrical wiring from the fastening on the ignition/injection system control unit mount.
Proceed with the removal  - 1048A34  sleeve(s) from flow meter to air supply capacity case - r + r . 1. Disconnect the electrical connection from the throttle body integrated with D.V.L. and release the wiring from the band on the mount.

NameConnector
1Throttle body actuator  N75 
2. Undo nut (2a) and disconnect earth lead (2b) from the injection-ignition control unit mount

NameConnector
2bEarth on engine  C40C 
3. Undo the bolts securing the ignition/injection system control unit mounting.
The above bolts also secure the throttle body with integral DVL to the modular intake manifold.
1. Remove ignition/injection system control unit mount (1a) with control unit (1b).
1. Working at the bench, undo nuts (1a) and separate the ignition/injection system control unit mount (1b) from control unit (1c).
Refitting ( Removing ) 1. Working at the bench, assemble control unit (1a) to injection/ignition control unit mount (1b) and secure by tightening nuts (1c) to the specified torque.

FasteningComponentØValue(daNm)
1cNutINJECTION/IGNITION SYSTEM E.C.U.M6(Support side) 0.8÷1.1
1. Refit the ignition/injection control unit mount (1a) with control unit (1b) and secure by tightening bolts (1c) to the specified torque.
The above bolts also secure the throttle body with integral DVL to the modular intake manifold.

FasteningComponentØValue(daNm)
1cBoltBUTTERFLY VALVE CASE/S (MPI)M6(Modular intake manifold side) 0.8 ÷ 1.1
Connect the earth lead to the injection / ignition control unit mount and secure it with its bolt.Connect the electrical connection to the throttle body integrated with the D.V.L. and secure the wiring to the band on the mount.Proceed with the refitting  - 1048A34  sleeve(s) from flow meter to air supply capacity case - r + r .Connect the electrical connections to the injection-ignition control unit and secure the electrical wiring to the ignition/injection system control unit mount.Connect the battery terminal (-).