3025303 - 4130B52 heat exchanger pipe - r+r

Removing ( Refitting ) Position the vehicle on the ramp.Remove the power steering fluid reservoir and drain the fluid using a suitable syringe. Proceed with removal  - 7055B54  under-engine guard - r r . 1. Disconnect the quick-release fitting on the return pipe from power steering box to heat exchanger, heat exchanger side.2. Disconnect the rapid attachment coupling from the return pipe from the heat exchanger to the power steering fluid reservoir, heat exchanger side.
1. Undo nut (1a), undo clips (1b) and remove heat exchanger pipe (1c) complete with bracket (1d).
Refitting ( Removing ) Refit the heat exchanger pipe complete with support bracket and secure using the clips and nut.Connect the rapid attachment coupling on the return pipe from the heat exchanger to the power steering fluid reservoir, heat exchanger side.Connect the quick-release fitting on the return pipe from power steering box to heat exchanger, heat exchanger side. Proceed with refitting  - 7055B54  under-engine guard - r r . Fill the power steering circuit with the recommended fluid.

TypeComponentNameQty.
-Oli [l]POWER ASSISTED STEERING CIRCUITTUTELA GI/A1.2
Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.Check and, if necessary, top up the fluid level in the reservoir.Remove the car from the ramps.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left).Top up the fluid level in the reservoir.