1056B17 THROTTLE BODY INTERGRAL WITH DVL - R R - Alfa - 147 - eLearn

3024832 - 1056B17 throttle body intergral with dvl - r r

) Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1B

Proceed with the removal - 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r . Proceed with the removal - 1056B87 ignition/injection system control unit mount - r r . 1. Undo the remaining bolt (1a) and remove the throttle body integrated with D.V.L. (1b).

Refitting ( Removing

)

If the thottle body integral with DVL is replaced, run the injection-ignition initialisation procedure - 1056B81 run electronic ignition/injection control unit (single) self-learning procedure

Refit the throttle body with integral DVL in its housing and secure provisionally with the bolt.

Tighten the above bolt to the specified torque at the same time as the remaining bolts that secure the ignition/injection control unit mount are tightened.

Proceed with the refitting - 1056B87 ignition/injection system control unit mount - r r .Proceed with the refitting - 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r .Connect the battery terminal (-).