3025327 - 4410c10 front suspension stabilizer bar - r+r - check wheel geometry separately

Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

Proceed with removal  - 4450B12  front or rear wheels (two) - r+r . Refitting ( Removing ) Replace the front suspension anti-roll bar in its housing.Raise the front suspension beam as necessary using the hydraulic jack.1. Place the front suspension anti-roll bar joints (1a) back in their housings and secure by tightening nuts(1b) and (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Nut	FRONT ANTI-ROLL BAR JOINTS	M10	(Front shock absorber fork side) 4.1 ÷ 5.0

	Fastening	Component	Ø	Value(daNm)
1c	Nut	FRONT ANTI-ROLL BAR JOINTS	M10	(Anti-roll bar side) 4.5 ÷ 5.5

Fully raise the front suspension beam using the hydaulic jack.1. Tighten the side bolts securing the front suspension crossmember to the bodyshell to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1	Side bolt	ENGINE OR ROD ANCHORAGE BEAM	M12	(Bodyshell side) 10.8 ÷ 13.2

2. Tighten the rear bolts securing the front suspension crossmember to the bodyshell to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2	Rear bolts	ENGINE OR ROD ANCHORAGE BEAM	M12	(Bodyshell side) 10.8 ÷ 13.2

	Fastening	Component	Ø	Value(daNm)
2	Rear bolt	ENGINE OR ROD ANCHORAGE BEAM	M10	(Bodyshell side) 7.2 ÷ 8.8

3. Remove the hydraulic jack (3a) and tool (3b) supporting the front suspension crossmember.

	Name	Country
3b	Flange	1.860.978.000

4. Tighten the bolts securing the power steering box to the front suspension crossmember to the specified torque.

	Fastening	Component	Ø	Value(daNm)
4	Bolt	POWER STEERING BOX	M14	(Front suspension crossmember side) 11.7 ÷ 14.3

5. Tighten nuts (5a) and bolts (5b) securing the gearlever and handbrake lever mount.6. Tighten the bolts securing the antiroll bar to the front suspension crossmember to the specified torque.

	Fastening	Component	Ø	Value(daNm)
6	Bolt	FRONT ANTI-ROLL BAR	M8	(Front suspension crossmember side) 3.6 ÷ 4.4

Only on the GTA version, refit the underbody reinforcements in their seats and secure the bolts. Proceed with refitting  - 1008A44  rear rigid mount - r r .