3025513 - 5520A14 ignition key block - r+r
It is not possible to order a single lock barrel or to order barrels simply by using a part code. When ordering barrels, observe the special procedure set out in See assembly 5580E anti-theft device . |
1. Insert the ignition key in the lock barrel and turn to the ON
position.2. Using a screwdriver, insert the retaining tooth.3. Remove the lock barrel.
1. Remove the retaining ring at the rear of the ignition lock barrel.
1. Press the parking lights lever (1a) and turn the key until the
pin (1b) is positioned in the special slit.
1. Partly extract the key from the lock barrel to allow the lock
(1a) to move down and pass through the special slit, then extract
the lock barrel (1b).
Refitting
(
Removing
)
1. Fully insert the key in the lock barrel. Partly extract the key
from the lock barrel to allow the lock (1a) to move down and the
complete lock barrel to engage in the special housing (1b).
Fit the circlip at the rear
of the ignition lock barrel.Turn the ignition key to the ON position.Insert the barrel in the ignition and ensure
that the retaining tooth is engaged.Test the operation of the lock barrel (electrical
equipment and steering lock).Extract the ignition key.Refit the lower half casing fixing it using
the bolts.