3025615 - 5580C44 front side bag module one lh or rh r r

Before removing and refitting the Air Bag module, the following preliminary operations must be carried out:

Place the ignition key in the OFF position and extract it;- Disconnect the battery leads and insulate.- Wait for 10 minutes before continuing.

FOLLOW ALL THE RECOMMENDED SAFETY FULES ( See assembly 5580C   air bag system ).

Removing ( Refitting )  - 7045A10  l/h or r/h front seat (one) - r+r - 7045A25  squab lumbar knob - r r - 7045A84  Front set BACKREST COVER - R.R. with seat removed1. Undo the Air Bag module nuts.2. Move the Air Bag module slightly.3. Lift the safety retainer (3a) then remove the electrical connection (3b). Place the Air Bag module in the special cupboard, resting it on a free surface with the flat surface facing upwards. Refitting ( Removing ) Observe the following precaution.

Handle the side Air Bag with extreme caution. Ensure the battery is disconnected.

If a new module is being fitted, attach the labels as described below.1. Detach the removable part (1b) of the adhesive label from the new module (1a). Place a copy of the label (1b) in a specific file containing the vehicle details (model, registration data, chassis number) and the serial number of the old module. This file should be kept for future checks. 2. Apply the detachable part of the original label (1b) to the bottom of the seat, where there are already similar labels for the seat, squab cover and Air Bag wiring.

The severity of the impact could cause deformation of the seat frame. Proceed as follows to check frame condition.

Check visually for deformation or cracks in the seat frame.Check that the impact slots on the lower sides of the squabs are not deformed.Check that the welds and rivets on the joints between squab and cushion are undamaged.Check the squab for torsional deformation by measuring the diagonals of the squab frame. Check that the measurements are the same and that the diagonals intersect at the centre of the squab. Move the seat through all its various settings to ensure that movements take place without binding or noise.

If the checks have a favourable result, only the damaged components need be replaced (Air Bag module, wiring, cover).

Connect the electrical connection and engage the safety retainer.Refit the Air Bag module.Tighten the nuts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	FRONT SIDE AIR BAG MODULE ASSEMBLY.	M6	0.8

 - 7045A84  Front set BACKREST COVER - R.R. with seat removed - 7045A25  squab lumbar knob - r r - 7045A10  l/h or r/h front seat (one) - r+rCheck the operation of the system using the Examiner or another tester.

Before removing and refitting the Air Bag module, the following preliminary operations must be carried out:

Place the ignition key in the OFF position and extract it;- Disconnect the battery leads and insulate.- Wait for 10 minutes before continuing.

FOLLOW ALL THE RECOMMENDED SAFETY FULES ( See assembly 5580C   air bag system ).