7005A14 FRONT SIDE DOOR - ADJUST CENTERING AND MOULDING - INCLUDES ADAPTATION OF HINGES AND SEALS ON DOOR COMPARTMENT - Alfa - 147 - eLearn

3025638 - 7005A14 front side door - adjust centering and moulding - includes adaptation of hinges and seals on door compartment

1. Undo the bolt (1a) of the door check strap (1b) and close the door again to push the check strap back in. 2. Loosen the bolts using the appropriate tool.

	Name	Country
2	Key	1.822.120.000

3. Adjust the door position, making use of the bolt slots, so that it is perfectly aligned with the body.

It is advisable to work on one hinge at a time. Possible adjustment movements are indicated by arrows.

Fit shims between hinge and door if necessary to ensure the door is adjusted properly, proceeding as follows (the hinge position is adjusted using the door as reference). Remove the door striker, see op. 7005B14Working as described above, slacken the hinge bolts slightly.1. Move the door back in relation to the hinge attachment.2. Protect sharp edges of the body with adhesive tape.3. Unscrew the retaining bolts4. Fit the shims.

Screw in the bolts without tightening.Adjust the door position, making use of the movements of the bolt attachment plate, so that it is perfectly aligned with the body. Refit the door striker, see op. 7005B14Tighten the bolts with the appropriate tool.

	Name	Country
2	Key	1.822.120.000

1. After adjustment, undo the bolts on the hinge pins.2. Disconnect the electrical connections.

	Name	Connector
2	Rear coupling for /front door. driver's side	D30

	Name	Connector
2	/Front passenger door. rear coupling	D31

3. Lift the door and remove it.4. Tighten the hinge bolts.

	Fastening	Component	Ø	Value(daNm)
4	Bolt	FRONT SIDE DOOR HINGES	M10	4.5

Touch up the paintwork in the hinge area.Refit the door, securing it with the hinge pin bolts.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT SIDE DOOR HINGES	M6	1.5

Connect the electrical connectionCheck the various appliances on the door are working properly.Make the door check strap come out and tighten its bolt.Check that the striker and catch fit together properly. If necessary Refer to op.. 7005A10 front side door - adjust striker and adapt seal in necessary .