3025968 - 7210E75 tail light seat
Removing ( Refitting ) - 7210E52 R.R. REAR WINGCheck if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges). Straighten the body if necessary.
1. Use a rotary brush to clean the panel edges in order to expose
the weld spots.2. Cut along the the line shown using the hacksawing machine.3. Use a chamfering machine to crop weld points around the edge
of the light seat. Use a chisel and mallet to remove spots
drilled previously.4. Remove the cut edges from the headlamp seat.
Straighten the car edges using
a mallet and profiled stake.Use a grinding wheel to remove the weld
spot residues.Use a rotary brush to clean treated areas.1. Apply the electric weld paint finish.
1. Use a rotary brush to remove the corrosion-proofing from the
areas shown in the figure. Apply electrogalvanised paint on the newly-treated eges.
Refitting
(
Removing
)
1. Position the tail-light seat on the car correctly using the self-locking
grippers. 2. Tack the part by carrying out some spot welds.
1. Position the rear wing.2. Fit the tail-gate. Check alignment and gaps around the edges,
then remove the rear wing and the tail-gate.
1. Use a spot welder to weld the areas shown in the figure.
Correct any deformations in
the panel using a profiled stake and mallet.1. Use a grinding wheel to level the welds. Use a rotary brush to clean the newly-welded
areas.
1. Apply rust-proofing to newly-welded areas.Seal the joint lines between the part and
the car.Apply paint.
- 7210E52 R.R. REAR WING