3026265 - Introduction - SUSPENSION AND WHEELS

CAUTION

All operations should be carried out taking great care to avoid injury to persons.

The engine compartment contains numerous moving parts, components at high temperatures and electrical wiring with voltage. Follow these precautions scrupulously when carrying out operations in the engine compartment:

  • Switch off the engine and wait for it to cool down.
  • do not smoke
  • no naked flames
  • make sure that there is a fire extinguisher in the vicinity.
For some procedures, the use of special tools is indicated. The use of these tools is vital in order to work safely.Follow the safety instructions in force for workshop procedures. Where necessary, the Manual contains specific warnings to prevent the risk of dangerous situations.When using chemicals, closely follow the safety instructions given on the safety sheet which the supplier must give the user.The electronic ignition system generates voltages of 20,000 V and higher which could be very dangerous to people, especially if they suffer from a heart condition. Great care should be taken when working on this system or near its components.

WARNINGS

All the operations must be carried out with the utmost attention and care to avoid damaging the components.prevent brake-clutch fluid coming into contact with painted parts; If this should happen, wash immediately with water.Before any interventions on electrical components, including battery disconnection, make sure that the ignition is off ('STOP' position).In order to release parts which are sticking, tap lightly using an aluminium or lead hammer for ferrous materials, and a wooden or resin hammer for light alloy parts.During dismantling, check that parts which have to be marked carry reference marks.When refitting, lubricate the parts, where necessary, to prevent sticking or seizing during the initial operating period. During refitting, it is essential to observe the tightening torques and adjustment data.During each refitting, replace the gaskets, oil seals, spring washers, safety plates, self-locking nuts, pre-treated bolts and all components which have deteriorated.The replacement of removed assemblies or components should be carried out using genuine spare parts only: this is the only way that the interchangeability and perfect operation of the various components can be guaranteed.