3022414 - 1040A fuel tank and components

OPERATION

Immersed pump unit complete with fuel gauge sender unit

It mainly consists of:

  • an electric fuel pump (1)
  • a fuel filter (2)
  • a float type fuel gauge (3)
  • a diaphragm pressure regulator (4)
  • a mesh pre-filter (5).

Ekp 13.5 electric fuel pump

The fuel pump comprises a permanent-magnet electric motor (1) which controls the pump impeller (2), and a terminal-carrier cover (3), which contains the electrical and hydraulic connections.The pump stage is the single type with peripheral flow, with high performance in low voltage and temperature conditions.

Its advantages compared with pumps operating in accordance with the positive-displacement principle are:

  • lightweight
  • small in size.

Inertia switch

The inertia switch is fitted on the diver's side near the bolt fixing the running board to the front door pillar. In the case of an impact to the vehicle, it interrupts the connection to earth for the electric fuel pump and consequently the supply of fuel to the injection system.
A steel ball (1) mounted in a conical housing (2) is normally locked by the attraction force of an adjacent magnet.For specific acceleration loads, the ball is released from the magnetic clip and gradually comes out of the conical housing in an upwards movement following the angle of the cone.Above the ball, there is a quick-trip mechanism (3) which forms the normally closed (N.C.) electric circuit.When the mechanism is struck by the ball, it changes position from an N.C. circuit to a normally open (N.A.) circuit, eaking the fuel pump's earth circuit.The switch can be reset by pressing a button protected by a soft cover (4).
.
Even after an apparently minor impact, if there is a smell of fuel or leaks are noticed from the fuel system, do not turn the switch back on, but search for the cause of the problem and remedy it to prevent the risk of fire. Otherwise, if there are no leaks and the vehicle can be restarted, press the button to reactivate the pump.