3024894 - 1084A42 engine oil pressure warning light switch - r + r

Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1B

Proceed with the removal  - 7055B54  under-engine guard - r r . Proceed with the removal  - 1072C44  exhaust manifold heat shield on bulkhead - r+r . Proceed with the removal  - 1080B40  catalytic pre-converter - r r . 1. Disconnect the electrical connection from the engine oil pressure warning light switch.

	Name	Connector
1	Engine oil pressure sensor	K30

2. Undo and remove the engine oil pressure warning light switch. Refitting ( Removing ) Fit the engine oil pressure warning light switch in its seating and tighten it to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	-	OIL PRESSURE W/L	M14	(Engine crankcase side) 2.7 ÷ 3.3

Connect the electrical connection to the engine oil pressure warning light switch.Proceed with the refitting  - 1080B40  catalytic pre-converter - r r .Proceed with the refitting  - 1072C44  exhaust manifold heat shield on bulkhead - r+r .Proceed with the refitting  - 7055B54  under-engine guard - r r .Connect the battery terminal (-).Remove the car from the ramp.