3310A30 FRONT BRAKE CALIPER (ONE) - R.R. - Alfa - 147 - eLearn

3025192 - 3310A30 FRONT BRAKE CALIPER (one) - R.R.

) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

Proceed with removal - 4450B10 Front WHEEL (one) - R.R. .Proceed with removal - 3330E10 FLEXIBLE PIPE (one), left or right, to front brake calipers - R.R . .1. Remove the clip securing the brake caliper to the bracket.2. Disconnect the electrical connections for the brake pad wear cable.

	Name	Connector
2	Left brake pad wear sensor (switch)	K20

3. Remove the protective plugs (3a), undo the bolts (3b), then remove the front brake caliper (3c) with the pads.

Refitting ( Removing

) .

When fitting a new brake caliper, the latter is supplied to Parts with no brake fluid; it is therefore necessary to operate as follows:- slacken the bleed screw;- insert the end of a transparent tube in the hole on the bleed screw;- using a normal container with recommended brake fluid, insert brake fluid into the caliper until air bubbles emerge from the threaded hole where the hose is connected;- tighten the bleed screw.

Refit the front brake caliper complete with pads in its seating, tighten the bolts to the specified torque and fit the protective plugs.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT BRAKE CALIPER ASSEMBLY	M12	(Bracket side) 11.7

Connect the electrical connection for the brake pad wear cable.Refit in its seating the clip securing the brake caliper to the bracket.Proceed with refitting - 3330E10 FLEXIBLE PIPE (one), left or right, to front brake calipers - R.R . .Bleed the air from the hydraulic braking system - 3330A14 HYDRAULIC BRAKING SYSTEM - Bleed air .Proceed with refitting - 4450B10 Front WHEEL (one) - R.R. .Connect the negative (-) battery terminal.