3025322 - 4410B40 lower wishbone (with balljoint) of left or right front suspension (one) - r+r -check wheel geometry separately

Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1B

Proceed with the removal  - 4450B10  Front WHEEL (one) - R.R. . Proceed with the removal  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. . Proceed with the removal  - 7055B54  under-engine guard - r r . Proceed with the removal  - 4450C10  front pillar (one), l/h or r/h complete with wheel hub - r+r with wheel removed - check wheel geometry separately . 1. Undo the nuts (1a) and disconnect the front anti-roll bar joint (1b) from the fork.2. Remove the brake pad wear sensor electric wiring bracket.3. Undo bolt (3a) and remove the lower fork connecting the front suspension damper to lower wishbone (3b).4. Remove the wheel rpm sensor electric wiring and brake caliper hose bracket. 1. Undo the bolts securing the antiroll bar to the front suspension (wishbone removal side).Loosen the bolts fixing the anti-roll bar to the front suspension crossmember (opposite side to wishbone removal side).2. Remove bolts (2a) and remove front suspension lower wishbone (2b). Refitting ( Removing ) 1. Refit the front suspension lower wishbone (1a) in its seating and secure by tightening bolts (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	FRONT SUSPENSION LOWER LEVER	M10	(Front suspension crossmember side) 7.1 ÷ 7.9

2. Tighten the bolts securing the front anti-roll bar to the front suspension crossmember to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	FRONT ANTI-ROLL BAR	M8	(Front suspension crossmember side) 3.6 ÷ 4.4

1. Refit the lower fork connecting the front suspension damper to the lower wishbone (1a) complete with bracket (1b) and secure by tightening bolt (1c) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	FRONT DAMPER FORK ON WISHBONE	M12	(Shock absorber side) 7.2 ÷ 8.8

2. Connect the front anti-roll bar joint (2a) to the fork and secure together with bracket (2b) by tightening the nut (2c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2c	Nut	FRONT ANTI-ROLL BAR JOINTS	M10	(Front shock absorber fork side) 4.1 ÷ 5.0

Proceed with the refitting  - 4450C10  front pillar (one), l/h or r/h complete with wheel hub - r+r with wheel removed - check wheel geometry separately . Proceed with the refitting  - 7055B54  under-engine guard - r r . Proceed with the refitting  - 7055B64  Engine compartment DUST shield in front wheel arch (one), left or right - R.R. .Proceed with the refitting  - 4450B10  Front WHEEL (one) - R.R. .Connect the battery terminal (-).Remove the car from the ramp.It is advisable to check the wheel alignment  - 4450A10  front wheel geometry - check using optical equipment - includes front wheel tow-in adjustment if necessary .