3025503 - 5510C26 rpm sensor - r+r

Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF postition, then disconnect the battery negative terminal.

	Name	Connector
-	Battery	A1B

1. Disconnect the electrical connection for the engine rpm sensor.

	Name	Connector
1	RPM sensor	K46

Proceed with the removal  - 7055B54  under-engine guard - r r . Proceed with the removal  - 1072C44  exhaust manifold heat shield on bulkhead - r+r . Proceed with the removal  - 1080B40  catalytic pre-converter - r r . Release the electrical wiring for the engine rpm sensor from the fastenings on the modular intake manifold.1. Undo the bolt (1a) and remove the engine rpm sensor (1b). Refitting ( Removing ) Place the engine rpm sensor back in its housing and secure it by tightening the bolt to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	-	RPM SENSOR	M6	(Crankase side) 0.9

Secure the electrical wiring for the engine rpm sensor to the fastenings on the modular intake manifold.Proceed with the refitting  - 1080B40  catalytic pre-converter - r r .Proceed with the refitting  - 1072C44  exhaust manifold heat shield on bulkhead - r+r .Proceed with the refitting  - 7055B54  under-engine guard - r r .Connect the electrical connection for the engine rpm sensor.Connect the battery terminal (-).Remove the car from the ramp.