| | Results of the tests |
| 1 | REEL CHECK | All OK | Problems met | Operation |
|---|
| Check
that the reel is fitted correctly, checking that the reference pin
is correctly positioned in the bodyshell housing | Continue to Step 2 | Fitting irregular | Loosen the fixing bolt and
position the reference lug correctly Retighten the bolt to the recommended
torque |
| 2 | CHECK FOR PRESENCE OF FOREIGN BODIES | All OK | Problems met | Operation |
|---|
| Check
that there are no foreign bodies inside the system | Continue to Step 3 | Presence of foreign bodies | Remove foreign bodies |
| 3 | BELT CHECK | All OK | Problems met | Operation |
|---|
| Check
that there is no interference, deformation or marks caused by accidents | Continue to Step 4 | There is interference
which slows down the sliding of the front belts | Eliminate the interference,
if necessary, replace the belts Op. 7065A12 |
| There is interference which slows down the sliding of
the rear belts | Eliminate the interference, if necessary, replace the
belts Op. 7065B10 |
| Presence of distortions on the front mounting rod | Replace the front rod Op. 7065A14 |
| Presence of distortion on the rear mounting rod | Replace the rear rod Op. 7065B14 |
| Presence of distortion on the front reel/pretensioner | Replace the front belt Op. 7065A12 |
| Presence of distortion on the rear reel | Replace the rear belt Op. 7065B10 |
| 4 | PRETENSIONER OPERATION CHECK | All OK | Problems met | Operation |
|---|
| Check
that the pretensioner has not been activated as a result of an accident.
If this is the case there would be white powder on the spring casing,
the reel would locked and/or the belt deteriorated | Continue to Step 5 | Evidence of pretensioner
activated | Replace the belt Op. 7065A12 |
| 5 | REEL RELEASE SYSTEM CHECK | All OK | Problems met | Operation |
|---|
| Check
the reel release, rewinding the belt for a brief section and gently
unwinding it | Continue to Step 6 | Front reel release system
faulty | Replace
the front belt Op. 7065A12 |
| Rear reel release system faulty | Replace the rear belt Op. 7065B10 |
| 6 | CHECK ON CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | | Fault persists | Search for the fault starting from another symptom' |