3022770 - Z50 MIXTURE STRENGTH ERROR

The diagnostic equipment signals the following error: Mixture strength
Results of the tests
0PRELIMINARY CHECKSAll OKProblems metOperation
Connect the diagnostic equipment (Examiner or Examiner Plus) and record the errors and environmental parameters.Check for the 'Mixture strength' error onlyEnd of diagnosisThe 'Upstream Lambda signal' error is presentContinue according to the instructions inSee table   Z56 
Only the 'Mixture strength', 'Misfire', 'Catalyzer' and/or 'Downstream Lambda signal' errors are presentContinue to Step 1
Other errors are present Identify and eliminate the cause of the problem
1SIGNAL PLAUSIBILITY CHECKAll OKProblems metOperation
Checking the plausibility of the flow meter signal by carrying out the Test See Test   1056BX  MAP/flow meter signal plausibility Continue to Step 2The signal is not plausibleReplace the flow meter Op. 1056B12
2ERROR DETAIL CHECKAll OKProblems metOperation
Check the detail of the 'Mixture strength' errorEnd of diagnosisThe detail is 'Above the upper limit'See table   Z52 
The detail is 'Air leaks downstream of flow meter'See table   Z52 
The detail is 'Below the lower limit'See table   Z51