3025306 - 4130B72 Return PIPE from POWER ASSISTED STEERING BOX to INTERMEDIATE PIPE - R.R.

Removing ( Refitting ) Position the vehicle on the ramp.Proceed with removal  - 7055B54  under-engine guard - r r .Proceed with removal  - 4450B02  left front wheel r r .1. Working from the left wheel arch, disconnect the return pipe from power steering box to the rigid pipe on the rigid pipe side.

Collect the power assisted steering fluid in a suitable container.

Proceed with removal  - 5530B10  battery - r+r .Proceed with removal  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. .1. Undo the connector (1a), disconnect the return pipe from the power assisted steering box to the rigid pipe (1b), power assisted steering box side, and remove it. Refitting ( Removing ) 1. Place the return pipe from power steering box to the intermediate pipe (1a) back in its housing, connect it to the power steering box and secure by tightening the connector (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	-	-	-	-

Proceed with refitting  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. .Proceed with refitting  - 5530B10  battery - r+r .Connect the return pipe from power steering box to the rigid pipe on the rigid pipe side and tighten the band.Proceed with refitting  - 4450B02  left front wheel r r .Proceed with refitting  - 7055B54  under-engine guard - r r .Fill the power steering circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	HYDRAULIC POWER ASSISTED STEERING SYSTEM	TUTELA GI/A	1.2

The table shows the total quantity of fluid present in the power assisted steering circuit.

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.Check and, if necessary, top up the fluid level in the reservoir.Remove the car from the ramps.Start the engine and carry out 4 - 5 full steering wheel turn cycles (right and left).Top up the fluid level in the reservoir.