3024832 - 1056B17 throttle body intergral with dvl - r r

Removing ( Refitting ) Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

Proceed with removal  - 1048A48  throttle heater sleeve - r r .1. Disconnect the electrical connection from the throttle body integrated with the D.V.L.

	Name	Connector
1	Throttle body actuator	N75

2. Undo the bolts (2a) and remove the throttle body integrated with D.V.L. (2b).Remove the gasket. Refitting ( Removing ) Replace the throttle casing integrated with D.V.L, complete with gasket, back in its housing and fix it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	BUTTERFLY VALVE CASE/S (MPI)	M6	(Air chamber side) 0.8 ÷ 1.1

Connect the electrical connection to the throttle body integrated with the D.V.L.Proceed with refitting  - 1048A48  throttle heater sleeve - r r .Connect the negative (-) battery terminal.

If a new throttle casing integrated with D.V.L. is being fitted, carry out the self-learning procedure for the injection/ignition control unit  - 1056B81  run electronic ignition/injection control unit (single) self-learning procedure .