3025181 - 2710A10 drive shaft with joints (one), l/h or r/h - r + r

Removing ( Refitting ) Position the vehicle on the ramp.Proceed with removal  - 4450B10  Front WHEEL (one) - R.R. .1. Remove the two bevels and undo the nut securing the hub nut to the drive shaft.

Use a 36 mm USAG spanner modified as shown in the figure to unscrew the nut.

Proceed with removal  - 4410A80  damper lower fork - r r .1. Undo the bolts (1a) and remove the driveshaft, complete with joints (1b). Refitting ( Removing ) 1. Place the driveshaft, complete with joints (1a), back in its housing and fix it tightening the bolts (1b) the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	-	-	-	-

	Fastening	Component	Ø	Value(daNm)
1b	-	-	-	-

Proceed with refitting  - 4410A80  damper lower fork - r r . 1. Tighten the nut (1a) fixing the wheel hub to the drive shaft to the recommended torque, using the angle tightening tool (1b).

	Fastening	Component	Ø	Value(daNm)
1a	Nut	FRONT HUB WITH BEARINGS	M24	(Driveshaft side) 6.7 ÷ 7.4 + 39 ÷ 43 

	Name	Country
1b	Protractor	1.860.942.000

1. Bevel the collar of the nut in two places as shown in the figure. Proceed with refitting  - 4450B10  Front WHEEL (one) - R.R. .Position the vehicle on the ramp.