3024975 - 1056B62 l/h and r/h fuel pipe assembly - with injectors - r + r

Removing ( Refitting ) Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

Proceed with removal  - 1072B42  left hand or right hand inlet manifold (one) - r+r .Discharge the fuel system pressure with the tool connected to the bleed valves on the fuel pipe.

	Name	Country
-	Rapid connector	1.870.684.000

1. Disconnect the quick-release connector for the front fuel supply pipe, fuel pipe side.2. Disconnect the electrical connections from the injectors.

	Name	Connector
2	Injector	N70

3. Undo the bolts (3a) and remove the fuel pipe (3b) complete with injectors (3c).

Precautions to be taken for the rapid connector between the pipe connecting the right and left fuel manifolds.

Avoid working with the engine hot under all circumstances;Never use tools such as pliers, screwdrivers, etc. under any circumstances;If it is released, rotate the rapid connector cover before acting on the release buttons;Check its condition (deformation/breakage of retaining lugs, release buttons) before reconnecting it;After re-engageing the rapid connector, check that it is correctly attached by pulling it;At the end of fitting, check that there are no fuel leaks by starting up the engine again;If there is damage to the rapid connector, replace the complete right pipe. Refitting ( Removing ) Place the fuel pipe, complete with injectors, back in its housing and fix it using the bolts.Connect the electrical connections to the injectors.Connect the quick-release connector for the front fuel supply pipe, fuel pipe side.Proceed with refitting  - 1072B42  left hand or right hand inlet manifold (one) - r+r .Connect the negative (-) battery terminal.