3025341 - 4420B18 rear wishbone - r r

Removing ( Refitting ) Position the vehicle on the ramp.Proceed with removal  - 4450B11  WHEEL (one) rear - R.R. .1. Undo bolt (1a) and disconnect the rear suspension rear wishbone (1b) from the rear steering knuckle.2. Remove the spacer.
1. Undo the bolt (1a) and remove the rear suspension rear wishbone (1b).
Refitting ( Removing ) 1. Refit the rear suspension rear wishbone (1a) and secure temporarily by means of nut (1b).
1. Connect the rear suspension rear wishbone (1a) with spacer (1b) to the rear steering knuckle and secure it without tightening the bolt (1c).
1. Place the suspension in a geometric configuration so that the difference in height between dimension D-C is 13 mm.
this distance is valid for all versions and does not depend on the weight of the vehicle and is designed to prevent torsional pre-loading of the flexible bushes.
1. Tighten the bolt connecting the track control arms to the shock absorber to the recommended torque.

FasteningComponentØValue(daNm)
1cBoltREAR SUSPENSION REAR WISHBONESM12(Rear wheel hub stub axle side.) 11.1 ÷ 13.5
Proceed with refitting  - 4450B11  WHEEL (one) rear - R.R. .Remove the car from the ramps.Proceed with refitting  - 4450A40  rear wheel geometry - check using optical equipment . Removing ( Refitting ) Position the vehicle on the ramp.Proceed with removal  - 4450B11  WHEEL (one) rear - R.R. .1. Undo bolt (1a) and disconnect the rear suspension rear wishbone (1b) from the rear steering knuckle.2. Remove the spacer.3. Undo the bolt (3a) and remove the rear suspension rear wishbone (3b).
Refitting ( Removing ) 1. Refit the rear suspension rear wishbone (1a) and secure temporarily by means of nut (1b).2. Connect the rear suspension rear wishbone (2a) with spacer (2b) to the rear steering knuckle and secure it by screwing in bolt (2c) without tightening.
1. Place the suspension in a geometric configuration so that the difference in height between dimension D-C is 13 mm.
This distance is valid for all versions and does not depend on the weight of the vehicle and is designed to prevent torsional pre-loading of the flexible bushes.
1. Tighten the bolt connecting the track control arms to the shock absorber to the recommended torque.

FasteningComponentØValue(daNm)
1BoltREAR SUSPENSION REAR WISHBONESM12(Rear wheel hub stub axle side.) 11.1 ÷ 13.5
Proceed with refitting  - 4450B11  WHEEL (one) rear - R.R. .Remove the car from the ramps.Proceed with refitting  - 4450A40  rear wheel geometry - check using optical equipment .