3024721 - 0010T20 coolant change

Position the vehicle on the ramp.Undo the engine coolant reservoir cap.Proceed with removal  Refer to op.. 7055B54  under-engine guard - r r .1. Disconnect the lower coolant outlet hose from the radiator and drain the engine coolant.

Recover the coolant using a suitable container.

1. Open the bleed screws (1a) on the radiator the ones (1b) on the water pump rigid inlet pipe. Connect the lower coolant outlet hose from the radiator.Proceed with refitting  Refer to op.. 7055B54  under-engine guard - r r .Remove the car from the ramps.1. Fill the system by slowly pouring the specified coolant into the engine coolant reservoir, without exceeding the MAX mark on the reservoir.

	Type	Component	Name	Qty.
-	Fluid [l]	ENGINE COOLING CIRCUIT	Mixture 50% Paraflu11 for Alfa Romeo/distilled water	6.3

Close the bleed on the radiator as soon as liquid starts to spill out.Continue filling until fluid comes out of the bleed screw on the water pump rigid inlet pipe, then close the bleed screw.Finish filling until the MAX level on the engine coolant reservoir is reached.Start the engine and run it at idle speed for 2 or 3 minutes.If necessary top up the engine coolant reservoir up to the MAX level.Refit the engine coolant reservoir cap.Pump the accelerator periodically and gradually up to about 3000 rpm.In order to check that the coolant circulation is correctly activated, turn on the heater to the maximum temperature and make sure that the air coming out of the vents is hot; after the check has been carried out, switch off the heater.If the engine coolant level in the reservoir is considerably below the MIN mark, undo the cap very carefully and top it up to the MAX level, then retighten the cap.Wait until the fan has activated a t least a couple of times.Stop the engine and wait for the fluid to cool down.If necessary, unscrew the reservoir cap with the engine cold and top up to the MAX level. Position the vehicle on the ramp.Undo the engine coolant reservoir cap.Proceed with removal  Refer to op.. 7055B54  under-engine guard - r r .1. Disconnect the lower coolant outlet hose from the radiator and drain the engine coolant.

Recover the coolant using a suitable container.

1. Open bleed fittings (1a) on the radiator, (1b) on the rigid coolant intake pipe to the coolant pump and (1c) on the rigid pipe carrying coolant to the engine oil heat exchanger. Connect the lower coolant outlet hose from the radiator.Proceed with refitting  Refer to op.. 7055B54  under-engine guard - r r .Remove the car from the ramps.1. Fill the system by slowly pouring the specified coolant into the engine coolant reservoir, without exceeding the MAX mark on the reservoir.

	Type	Component	Name	Qty.
-	Fluid [l]	ENGINE COOLING CIRCUIT	Mixture 50% Paraflu11 for Alfa Romeo/distilled water	7.2

Close the bleed on the radiator as soon as liquid starts to spill out.Continue adding coolant until it emerges from the bleed fittings on the rigid inlet pipe to the water pump and on the rigid pipe carrying coolant to the engine oil heat exchanger, then close the bleed fittings.Finish filling until the MAX level on the engine coolant reservoir is reached.Start the engine and run it at idle speed for 2 or 3 minutes.If necessary top up the engine coolant reservoir up to the MAX level.Refit the engine coolant reservoir cap.Pump the accelerator periodically and gradually up to about 3000 rpm.If the fluid in the engine coolant reservoir reaches the MIN mark, undo the cap very carefully and top up to the MAX level, then retighten the cap.Wait until the fan has activated a t least a couple of times.Stop the engine and wait for the fluid to cool down.If necessary, unscrew the reservoir cap and top up to the MAX level.