1008B20 POWER UNIT INTERMEDIATE MOUNT FLEXIBLE BLOCK - REPLACE - Alfa - 147 - eLearn

3024756 - 1008B20 power unit intermediate mount flexible block - replace

) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF position, then disconnect the battery negative terminal. - 7055B54 under-engine guard - r r .1. Undo the nut (1a) and bolt (1b) and remove the power unit rear rigid mount (1c).

1. Position a hydraulic jack under the power unit rear rigid mounting.2. Undo the bolt securing the power unit rear rigid mounting to the flexible mounting.Lower the power unit rigid rear support, as necessary, using the hydraulic jack.3. Undo the bolts (3a) and remove the flexible mounting for the power unit rear support (3b).

Refitting ( Removing

) Place a new flexible mounting for the power unit rear support (1a) back in its housing and secure it by tightening the bolts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	INTERM RUBBER MOUNT	M8	2.7 - 3.4

Place the rigid rear support for the power unit back in its housing using the hydraulic jack.Tighten the bolt securing the rigid rear power unit support to the flexible mounting to the recommended torque.Remove the hydraulic jack from under the power unit rigid rear support.Proceed with the refitting - 7055B54 under-engine guard - r r .Connect the battery terminal (-).Remove the car from the ramp.