3025070 - 1084A40 engine oil level sensor - r + r

Removing ( Refitting ) Place the car on a ramp.Disconnect the battery negative terminal.Raise the lift. - 7055B54  under-engine guard - r r1. Undo the nut (1a) and bolt (1b) and remove the power unit rear rigid mount reinforcement (1c). 1. Disconnect the electrical connection from the switch.

	Name	Connector
1	Engine oil level sensor	K32

2. Undo and remove the engine oil pressure warning light switch. Refitting ( Removing ) Fit the engine oil pressure warning light switch.

	Fastening	Component	Ø	Value(daNm)
-	Sensor	OIL LEVEL DIPSTICK SENSOR	M12 x 1.25	3

Connect the electrical connection

	Name	Connector
-	Engine oil level sensor	K32

Fit the rigid mount reinforcement and secure to the block and crankcase.Tighten the reinforcement retaining bolt and nut to torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	POWER UNIT RIGID REAR SUPPORT REINFORCEMENT ROD....	M12	(Flexible mounting) 7.9 ÷ 9.7

	Fastening	Component	Ø	Value(daNm)
-	Bolt	POWER UNIT RIGID REAR SUPPORT REINFORCEMENT ROD....	M10	(Cylinder block/crankcase) 4.5 ÷ 5.5

 - 7055B54  under-engine guard - r rLower the lift.Connect the battery negative terminal.Remove the vehicle from the ramp.