3025417 - 5040A44 air conditioner dehydrating filter/accumulator - r+r

Follow the safety instructions ( See subassembly 5040   AIR CONDITIONING CASING AND COMPONENTS ).

Removing ( Refitting )  - 7055B54  under-engine guard - r r - 5040B14  air conditioner system multi-level pressure switch - r+r1. Undo the bolts fixing the pipe connectors.2. Disconnect the connector from the drier filter.

Seal the disconnected connectors, using suitable plugs, to prevent humidity and impurities from entering the system.

3. Undo the bracket retaining bolt.4. Remove the bracket.5. Recover the drier filter. 1. If necessary, undo the bolts fixing the support.2. Remove the mount. Refitting ( Removing ) Check that the drier filter is intact and there are no signs of damage.If removed, position the mount and fix it using the nuts.Follow these precautions:

Do not leave the filter with the connectors disconnected for longer than is strictly necessary.

Replace the O-rings for the connectors.

- Use only green coloured seals, resistant to R134A coolant fluid.

- Lubricate the threads of the connectors using anti-freeze.

1. Connect the pipe connectors without tightening the fixing bolts.2. Position the drier filter.3. Position the bracket.4. Tighten the bolt.5. Tighten the bolts fixing the connectors to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	COOLANT SYSTEM FITTINGS	M6	0.9

 - 5040B14  air conditioner system multi-level pressure switch - r+r - 7055B54  under-engine guard - r rRepressurize using coolant fluid ( - 5040A10  Air conditioning refrigerant CIRCUIT - Draining and Refilling ).