3024875 - 1080B62 catalytic converter - r + r
Removing
(
Refitting
)
Place the car on a ramp.Raise the lift.1. Remove rubber blocks (1a) from retaining pins (1b).2. Undo the bolts securing the catalytic convertor to the front
section of the exhaust pipe.3. Undo the bolts securing the catalytic converter to the intermediate
silencer.4. Remove the catalytic converter.
Refitting
(
Removing
)
1. Fit the catalytic converter and tighten the retaining bolts with
the exhaust pipe front section.2. Secure the rubber mountings (2a) to the pins on the bodyshell
(2b).3. Tighten the bolts fixing the catalytic converter to the intermediate
silencer.4. Tighten the bolts securing the catalytic converter to the front
exhaust pipe section. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 4 | Bolt | EXHAUST PIPE TO ENGINE | M8 | (catalytic converter) 3 |
 | Check that distance A shown in the figure, on both sides of the supports, between the bracket on the floor and the bracket for the silencer, measured inside them near the rubber mountings, is not less than 25 mm. If the values are lower, fold the silencer mounting bracket, ensuring that the distance is correct (25 - 28 mm). |
