3025327 - 4410c10 front suspension stabilizer bar - r+r - check wheel geometry separately

Removing ( Refitting ) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

NameConnector
-Battery  A1B 
Proceed with removal  - 4450B12  front or rear wheels (two) - r+r . Proceed with removal  - 7055B54  under-engine guard - r r . Proceed with removal  - 1076B50  exhaust pipe attachment to engine - r + r . Refitting ( Removing ) Replace the front suspension anti-roll bar in its housing.Raise the front suspension beam as necessary using the hydraulic jack.1. Place the front suspension anti-roll bar joints (1a) back in their housings and secure by tightening nuts(1b) and (1c) to the recommended torque.

FasteningComponentØValue(daNm)
1bNutFRONT ANTI-ROLL BAR JOINTSM10(Front shock absorber fork side) 4.1 ÷ 5.0

FasteningComponentØValue(daNm)
1cNutFRONT ANTI-ROLL BAR JOINTSM10(Anti-roll bar side) 4.5 ÷ 5.5
Fully raise the front suspension beam using the hydaulic jack.1. Tighten the side bolts securing the front suspension crossmember to the bodyshell to the recommended torque.

FasteningComponentØValue(daNm)
1Side boltENGINE OR ROD ANCHORAGE BEAMM12(Bodyshell side) 10.8 ÷ 13.2
2. Tighten the rear bolts securing the front suspension crossmember to the bodyshell to the recommended torque.

FasteningComponentØValue(daNm)
2Rear boltsENGINE OR ROD ANCHORAGE BEAMM12(Bodyshell side) 10.8 ÷ 13.2

FasteningComponentØValue(daNm)
2Rear boltENGINE OR ROD ANCHORAGE BEAMM10(Bodyshell side) 7.2 ÷ 8.8
3. Remove the hydraulic jack (3a) and tool (3b) supporting the front suspension crossmember.

NameCountry
3bFlange1.860.978.000
4. Tighten the bolts securing the power steering box to the front suspension crossmember to the specified torque.

FasteningComponentØValue(daNm)
4BoltPOWER STEERING BOXM14(Front suspension crossmember side) 11.7 ÷ 14.3
5. Tighten nuts (5a) and bolts (5b) securing the gearlever and handbrake lever mount.6. Tighten the bolts securing the antiroll bar to the front suspension crossmember to the specified torque.

FasteningComponentØValue(daNm)
6BoltFRONT ANTI-ROLL BARM8(Front suspension crossmember side) 3.6 ÷ 4.4
Only on the GTA version, refit the underbody reinforcements in their seats and secure the bolts.
Proceed with refitting  - 1008A44  rear rigid mount - r r . Proceed with refitting  - 1076B50  exhaust pipe attachment to engine - r + r . Proceed with refitting  - 7055B54  under-engine guard - r r . Connect the negative (-) battery terminal.Remove the car from the ramps.It is advisable to check the wheel alignment  - 4450A10  front wheel geometry - check using optical equipment - includes front wheel tow-in adjustment if necessary .