3025115 - 1820B54 hose from damper - r r
Removing
(
Refitting
)
Proceed with removal - 7025A12 Engine front sound insulation
COVER - R.R. .Proceed with removal - 7025A14 Bonnet LID - R.R. .Proceed with removal - 1016A10 sound-proofing cover
- r + r .Proceed with removal - 5530B10 battery - r+r .Proceed with removal - 5530B52 Battery DRIP TRAY/SUPPORT
- R.R. .Remove the protective cap on the master
cylinder bleed valve.Connect the collection system (pipe and
reservoir) to the bleed valve on the clutch operating cylinder.Operate the clutch pedal until the brake-clutch
fluid reservoir is empty.1. Undo the connector (1a) and disconnect the pipe from the vibration
damper to the operating cylinder (1b), operating cylinder side.2. Remove the split pin (2a) and disconnect the pipe from the vibration
damper to the operating cylinder (2b), vibration damper side.3. Remove the pipe from the vibration damper to the operating cylinder
(3a) after having released it from the band (3b).
Refitting
(
Removing
)
1. Place the pipe from the vibration damper to the operating cylinder
(1a) back in its housing and secure it to the band (1b).2. Connect the pipe from the vibration damper to the operating cylinder
(2a), vibration damper side and secure it using the split pin (2b). 3. Connect the pipe from the vibration damper to the operating cylinder
(3a), operating cylinder side and tighten the connector (3b) to
the recommended torque. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| 3b | - | - | - | - |
