3362531 - 1020A26 CRANKCASE SUMP - R.R CLEAN MATING SURFACES AND APPLY SEALANT FOR VEHICLES WITH AIR CONDITIONING

Removing ( Refitting ) Position the vehicle on a lift.Raise the lift.Position a suitable container for collecting the engine oil.1. Undo the engine oil drain plug and remove it.
    Op. 1076B18 RIGID SECTION OF EXHAUST PIPE BETWEEN CATALYTIC CONVERTER AND SILENCER - R + R    Op. 1084A16 OIL DIPSTICK PIPE - R.R 1. Undo the bolts fixing the engine oil sump to the crankcase (1a) and to the gearbox (1b).
1. Cut the engine oil sump bead of sealant using the special blade.
DescriptionCodeFunction
1Blade1.870.718.000Cut sealant
1. Remove the engine oil sump complete with anti-splash partition.
Refitting ( Removing ) Using a suitable tool, reface the thread for the seats for the oil sump fixing bolts.Apply a bead of silicon sealant paste about 2 mm thick to the contact areas between the engine block, 5th main bearing cap (flywheel side) and the oil pump module.1. Apply a bead of silicon sealant paste about 3 mm thick to the edge of the sump and around the oil recirculation and inlet connectors.
1. Fit the engine oil sump complete with anti-splash partition.
Apply thread-locking agent to the fixing bolts.1. Tighten the bolts (1a) fixing the engine oil sump to the crankcase and the bolts (1b) fixing the oil sump to the gearbox to torque.
Value daNmFasteningComponentØ  
1a1Bolt--
Value daNmFasteningComponentØ  
1b4Bolt--
    Op. 1084A16 OIL DIPSTICK PIPE - R.R    Op. 1076B18 RIGID SECTION OF EXHAUST PIPE BETWEEN CATALYTIC CONVERTER AND SILENCER - R + R 1. Fit the engine oil drain plug in place and tighten to torque.
Value daNmFasteningComponentØ  
11.4Plug--
    Op. 0010T10 CHANGE ENGINE OILLower the lift.Remove the vehicle from the lift.