3360171 - A31 ALARM DOES NOT COME ON WHEN LUGGAGE COMPARTMENT IS CLOSED

When the alarm is on, the system will not come on again after one boot lid open/closure cycle.
One second after the boot lid opening command (via remote control), the system automatically reactivates if boot lid opening is not detected by turning volumetric, anti-tilt and perimeter protections back on.
Results of the tests
1CHECKING WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Connect the diagnostic equipment to the body computer node and check boot lid status (open or closed) is properly received while in parameter mode.Continue to Step 4Boot lid status not received.Continue to Step 2
2CHECKING ELECTRICAL CIRCUITAll OKProblems metOperation
Check that the electrical connection between boot switch and body computer node is not broken or insulated.Continue to Step 3Electrical connection broken or not insulated.Restore continuity/insulation of the electrical connection between boot switch and body computer node. See   E7015  ALARM
3CHECKING COMPONENT OPERATIONAll OKProblems metOperation
Disconnect the connector on the body comuter node side and check for a boot open/closed signal. See   E7015  ALARM Continue to Step 4Boot electrical switch not workingChange the boot catch Op. 7025B38
4CHECKING CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosisFault persistsChange the body computer node Op. 5505A32Search for the fault starting from another symptom'