3362438 - 1032D12 timing system protective cover(s) - r + r

Removing ( Refitting ) Place the car on a lift. - 5530B56  BATTERY DRIP TRAY COVER - R.R.Disconnect the battery negative terminal.1. Disconnect the rpm sensor electrical wiring.

	Name	Connector
1	RPM sensor	K46

2. Disconnect the electrical connection for the engine oil pressure switch.

	Name	Connector
2	Engine oil pressure sensor (switch)	K30

Release the electrical wiring for the rpm sensor from the retaining bands.1. Undo the fixing bolt (1a), then remove the upper timing protective cover (1b) releasing the electrical wiring for the rpm sensor. Raise the lift. - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1092B60  alternator drive belt - r + r - 1092A10  Crankshaft services PULLEY - R.R.1. Undo the bolts (1a) and remove the lower protective timing cover (1b). Refitting ( Removing ) Fit the lower protection and tighten the fixing bolts. - 1092A10  Crankshaft services PULLEY - R.R. - 1092B60  alternator drive belt - r + r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R.Lower the ramp.Fit the coupling for the rpm sensor in the housing in the upper cover.Fit the upper protective cover and secure it using the bolts.Secure the rpm sensor and low engine oil pressure electrical wiring to the timing belt protective cover.Connect the engine rpm sensor electrical connector.

	Name	Connector
-	RPM sensor	K46

Connect the electrical connection for the engine oil pressure switch.

	Name	Connector
-	Engine oil pressure sensor (switch)	K30

Connect the battery negative terminal. - 5530B56  BATTERY DRIP TRAY COVER - R.R.Remove the vehicle from the lift.