3362883 - 3340B56 RIGID PIPE from hydraulic CONTROL UNIT to RIGHT FRONT BRAKE - R.R.
Removing
(
Refitting
)
Place the car on a lift.
- 4450B12 front or rear wheels
(two) - r+r - 7055B54 under-engine guard - r r- 7055B64 Engine compartment DUST shield in front wheel arch
(one), left or right - R.R.
- 1076B50 exhaust pipe attachment to engine - r + r - 1008C30 power unit lower reaction link r r
1. Undo the bolts securing the anti-roll bar.2. Undo the bolts securing the steering box to the crossmember.Position a hydraulic jack under the crossmember.3. Undo the bolts securing the crossmember to the bodyshell.Lower the hydraulic jack.Remove the rigid pipe from the electrohydraulic
unit to the front right brake.
Refitting
(
Removing
)
Fit the rigid pipe from the
electrohydraulic control unit to the front right brake.Raise the jack until the crossmember is
fully home against the bodyshell.Tighten to torque the bolts securing the
crossmember to the body longitudinal member. | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| - | Bolt | ENGINE OR ROD ANCHORAGE BEAM | M14 x 1.5 | 15 |
| Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| - | Bolt | ENGINE OR ROD ANCHORAGE BEAM | M12 x 1.25 | 11. |
| Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| - | Bolt | ENGINE OR ROD ANCHORAGE BEAM | M12 x 1.25 | 8,5 |