3362883 - 3340B56 RIGID PIPE from hydraulic CONTROL UNIT to RIGHT FRONT BRAKE - R.R.

Removing ( Refitting ) Place the car on a lift.  - 4450B12  front or rear wheels (two) - r+r - 7055B54  under-engine guard - r r- 7055B64 Engine compartment DUST shield in front wheel arch (one), left or right - R.R.  - 5530B56  BATTERY DRIP TRAY COVER - R.R.- 5530B10 battery - r+r  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. - 1056B82  injection/ignition system e.c.u. (one) - r + r- 1040A31 fuel filler pipe - rigid section - r r  - 1056B14  throttle case - r + r - 1072B10  inlet manifold - r + r and replace seal - 1072D50  device (vis) with adjustable air ducts - r r  - 5530B56  BATTERY DRIP TRAY COVER - R.R.Disconnect the battery negative terminal. - 3340B52  pump/central obs pipe - r rRelease the rigid pipe from the ABS hydraulic control unit to the front right brake from the retaining clips present along the pipe.1. Using the special tool, disconnect the rigid pipe from ABS control unit to the right front brake from the hydraulic and electronic control unit.

NameCountry
-Spanner1.856.127.000
1. Using the special tool, undo the nut (1a) fixing the rigid pipe on the flexible connector to the front brake calipers and release the rigid pipe (1b).

NameCountry
-Box wrench for brake fittings1.856.132.000
 - 1076B70  exhaust pipe between pre-catalytic converter and catalytic converter - r r Refitting ( Removing ) Fit the rigid pipe from the electrohydraulic control unit to the front right brake.Raise the jack until the crossmember is fully home against the bodyshell.Tighten to torque the bolts securing the crossmember to the body longitudinal member.

FasteningComponentØValue(daNm)
-BoltENGINE OR ROD ANCHORAGE BEAMM14 x 1.515
Tighten to torque the bolts securing the crossmember brackets to the body longitudinal member.

FasteningComponentØValue(daNm)
-BoltENGINE OR ROD ANCHORAGE BEAMM12 x 1.2511.
Tighten to torque the bolts securing the steering box to the crossmember.

FasteningComponentØValue(daNm)
-BoltENGINE OR ROD ANCHORAGE BEAMM12 x 1.258,5
 - 1076B70  exhaust pipe between pre-catalytic converter and catalytic converter - r r